Selected project successes

Over 70 completed projects
World market leaders and specialised manufacturers
Project support across all development phases

Most of our projects come from the high-precision environment of semiconductor lithography and optics. We have also proven our expertise in machine tools, defence and aerospace.

A selection of our project successes

Increase in natural frequency from 180 Hz to 380 Hz

“Fully optimised” is rarely the last word

During the development of a new high-precision system for semiconductor lithography, the lowest natural frequency of a load-bearing frame had dropped to 180 Hz. However, the component required approximately twice the stiffness, and the assembly was considered fully optimised. We have:

  • Designed bolted joints for dynamic performance, combined components, reduced interfaces and added targeted stiffening in collaboration with the design team
  • Held workshops on designing for dynamic performance
  • Increased the natural frequency from 180 Hz to 380 Hz, more than doubling it
  • Improved positioning performance by a factor of 7
  • Completed up to 20 iterations per week instead of one iteration in around three months, calculating several thousand iterations over three years

Benefit for the client: We delivered an improvement that had been considered unrealistic and trained a design team that continues to design with dynamics in mind.

3.5% deviation between simulation and measurement

Ultra-precise means: Every system behaves as predicted

At a world-leading manufacturer of lithography optics, the natural frequencies of large load-bearing assemblies varied by up to 20 % from system to system, and mode shapes were barely predictable. We have:

  • Identified bolted joints with an unfavourable dynamic design as causes
  • Designed a new architecture with lighter, smaller components for dynamic performance and predictability
  • Demonstrated a 3.5% deviation between model prediction and measurement, with almost identical mode shapes, on the first system built

Benefit for the client: Systems that behave consistently. A simulation you can trust. Less rework during assembly and acceptance testing.

Unknown dynamic phenomena detected in 20% of machines

Overlapping dynamic effects: An error no one had encountered before

While simulating a high-precision system, we encountered a previously unknown phenomenon: dynamic effects in different assemblies can overlap, oscillate together and thus cause an imaging error. We have:

  • Used field data to show that the nominally separate effects coincide in around 20% of machines, precisely where the imaging error occurred
  • Identified targeted detuning of individual modes using additional masses and solution strategies for existing machines
  • Designed assemblies for the next generation to make a coincidence significantly less likely

Benefit for the client: A previously unexplained source of error understood. Fixed in the field. Avoided in new development.

Development of application-specific software for test data analysis

When the simulation result depends on the assumptions

Simulations are only as good as their assumptions. When assessing how vibrations and pressure fluctuations propagate through the water circuits of a high-precision system, the result depended on how many sub-regions the system was divided into, even though nothing in the system itself had changed. We have:

  • Identified the assumptions that were distorting the calculation results
  • Co-developed and corrected the calculation method and incorporated it into a MATLAB toolbox for assessment and analysis
  • Provided the documented toolbox to the client’s team, which has been using it independently ever since

Benefit for the client: Reliable results that no longer depend on the modelling. A tool the client uses independently.

Extremely short development times: days, not years

Quality loss in series production: from cause to remedy in a few days

In a multi-stage manufacturing process for a layered precision component, an international manufacturer was regularly losing parts to lower quality grades or scrap. We have:

  • Identified the thermal cause after one day on site and two to three further days of analysis – a level of understanding that had previously taken the client around two years to reach
  • Developed a research concept to systematically substantiate the causes on a small budget
  • Developed an early warning concept for optically predicting eventual product quality from the raw material
  • Built a demonstrator with our own multi-channel heating electronics and examined samples in our own laboratory

Benefit for the client: Rapid clarity on the cause. A strategy to prevent costly scrap. Robust evidence before any investment is made.

Facing a similar challenge?

Get in touch